Beast Master Version 2.
The Beast Master V2 is a fully patchable CMOS based synth device. It consists of the following modules. ( from left to right )
* 5 Square wave oscillators each with an output.
* 10 stage frequency divider with rate control and rate switch, hi or low range. Each out is diode protected, so you can stack the outs and then route it to a destination, similar to an OR combiner.
Super fun for beat creation.
* Tap Recorder based on a 64 stage shift register. The tap recorders clock can be either of the first two outs of the frequency divider or it can be turned of, all selectable by a 3 way switch. To enter data into the shift register tap the red momentary switch, to remove data tap the black momentary switch. The Tap Recorder has a tap gate output + Red LED and an inversion output + Blue LED.
* XOR gates x4. Each XOR gate has 2 inputs and 1 output. Feed it 2 audio rate oscillators for ring mod type sounds. Daisy chain the channels together for heavy SONIC ARCHITECTURE!
* 3 Vactrol based VCA's. Each VCA has an input, output and a CV in + LED.
* 5 channel passive mixer. 5 inputs 1 out. The first 2 channels have a LP filter switch.
Back panel:
* 1/4 audio out
* 9V dc power jack. Tip = - // sleeve = +
* Common Ground
**Easy patching with color coded banana jacks.
Black jack = input
Red jack = output
The Beast Master V2 is a fully patchable CMOS based synth device. It consists of the following modules. ( from left to right )
* 5 Square wave oscillators each with an output.
* 10 stage frequency divider with rate control and rate switch, hi or low range. Each out is diode protected, so you can stack the outs and then route it to a destination, similar to an OR combiner.
Super fun for beat creation.
* Tap Recorder based on a 64 stage shift register. The tap recorders clock can be either of the first two outs of the frequency divider or it can be turned of, all selectable by a 3 way switch. To enter data into the shift register tap the red momentary switch, to remove data tap the black momentary switch. The Tap Recorder has a tap gate output + Red LED and an inversion output + Blue LED.
* XOR gates x4. Each XOR gate has 2 inputs and 1 output. Feed it 2 audio rate oscillators for ring mod type sounds. Daisy chain the channels together for heavy SONIC ARCHITECTURE!
* 3 Vactrol based VCA's. Each VCA has an input, output and a CV in + LED.
* 5 channel passive mixer. 5 inputs 1 out. The first 2 channels have a LP filter switch.
Back panel:
* 1/4 audio out
* 9V dc power jack. Tip = - // sleeve = +
* Common Ground
**Easy patching with color coded banana jacks.
Black jack = input
Red jack = output
Peep my Etsy!
No comments:
Post a Comment